Unipulse DeviceNet F381A, Operation Manual

Page: 140 / 164

131
7 OPTION
131
OP
TION
Chapter
7
Operation
Main screen
→
Setting
→
First Setting
→
Option Setting
→
SD Card
→
Format
2.
To format, press .
■
Error messages
CAUTION
●
Format an SD memory card on the F381A or with dedicated formatting
software. Formatting it in other ways disables writing of measurement
waveforms at an average of approximately 1s because the SD memory card
processing speed becomes slow due to an inappropriate format for the F381A.
In that case, reformat it on the F381A before use.
●
During preservation and reading of data and formatting of an SD memory card,
a warning is displayed across the screen. Never eject the SD memory card or
turn off the power. Also, measurement cannot be started.
Error Description
Error 01
No SD memory card is set to the main unit. Check again to see if an SD memory
card is in the SD memory card slot, or if it is properly inserted.
Error 02
Initialization error. Initialization of the SD memory card was unsuccessful. Release
the error, and format the SD memory card again.
Error 03 The format is incompatible. The F381A format is FAT16.
Error 04
SD memory card processing is not ready.
Error 33 The SD memory card is write-protected.
Error 88
There is no file that can be read by the F381A.
Error 8B
This error is displayed when the number of files on the SD memory card is about to
exceed its capacity.
Error 8C Data cannot be preserved because the SD memory card has no free space.
Error 91
The data file is read-only.
Error BS
This error is displayed when a measurement waveform is not written
in time and the measurement start input OFF→ON is ignored.
It is reset by starting measurement with the error cleared or being
saved in time.
Other Errors
The cause is an indefinite error. The noise and the breakdown of SD memory card,
etc. are thought. It is necessary to review the working environment when frequently
happening.