2-4
Edition March 1995
2 - Introduction
■
Installation
■
General Information
The unit is to be connected to the power supply via the power cable
included in the delivery. Pay attention to all warnings and
instructions labeled or printed on the unit.
Electric circuit
The Ultre 3000/4000 Imagesetters are intended for operation in a
single-phase electric circuit with a grounded neutral conductor. Do
not connect the units to other types of electric circuits.
Make sure, that mains voltage and frequency of your power supply
match with mains voltage and frequency as indicated on the serial
number plate of the unit.
Installing
The unit should not be installed near air conditioning equipment
and is to be protected from humidity and direct sunlight. Unit
sockets and connection sockets should be near the unit and always
be easily accessible.
Ventilation
Take care that the unit is installed at a sufficient distance from the
walls (min. 80 cm) and other objects so that adequate ventilation
can be ensured. Ventilation outlets must be kept clear at all times.
The terminals located at the rear of the unit should be accessible.
If the unit is brought from a cold environment into the operation
room, condensation can occur. In this case, the unit should be
stored in the operation room for a minimum of six hours to
aclimatize it.
3000/4000 UM : Chapter 2 (Intro) Page 4 Wednesday, September 4, 1996 8:28 AM
