Ultre 3000/4000 - User Manual
6-7
Messages - 6
■
PHOTO ERROR
Possible Cause
SOL sensor failed to detect laser beam. This may be caused by a
JAM condition or Pressure Roller not in place during power on
diagnostics, or a malfunction in the optics assembly.
Corrective Action
If a JAM condition exists or the Pressure Roller Lever is not in the
down position, correct condition and reset machine by turning
power off and on. If condition reoccurs or a malfunction is suspect,
refer problem to a qualified technician.
■
POWER SUPPLY FAULT
Possible Cause
This error indicates a failure within the power supply.
Corrective Action
Reset the machine by turning the power off, waiting approximately
20 seconds and turning the power back on. If condition reoccurs
or a malfunction is suspect, refer problem to a qualified technician.
3000/4000 UM : Chapter 6 (Messages) Page 7 Wednesday, September 4, 1996 8:28 AM
