INSTALLATION INSTRUCTIONS
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH
APPROPRIATE ELECTRICAL CODES AND REGULATIONS.
WARNING:
IF YOU ARE NOT SURE ABOUT ANY PART OF THESE
INSTRUCTIONS, CONSULT A QUALIFIED ELECTRICIAN.
WARNING:
DO NOT CONNECT LINE VOLTAGE WIRES TO LOW-VOLTAGE
TERMINALS.
WARNING:
TO REDUCE THE RISK OF OVERHEATING AND POSSIBLE
DAMAGE TO THIS DEVICE AND OTHER EQUIPMENT, DO NOT INSTALL TO
CONTROL A RECEPTACLE.
WARNING:
USE ONLY WITH THE APPROPRIATE ADVANCE MARK X™
120V ELECTRONIC DIMMING BALLASTS FOR CONTROLLING THE
SPECIFIC FLUORESCENT LAMPS.
CAUTION:
USE WITH INCANDESCENT: (TUNGSTEN, 120V HALOGEN
FIXTURES), COLD CATHODE, MAGNETIC LOW- VOLTAGE TRANSFORMER
FIXTURES, OR MARK X™ 120V ELECTRONIC DIMMING BALLASTS ONLY.
DO NOT USE THIS PRODUCT TO CONTROL ELECTRONIC (SOLID STATE)
LOW- VOLTAGE TRANSFORMERS.
OTHER CAUTIONS:
1.
WHEN A MAGNETIC LOW- VOLTAGE CIRCUIT IS OPERATED AT A DIM
LEVEL, WITH ALL LAMPS INOPERATIVE, EXCESS CURRENT MAY
FLOW THROUGH THE TRANSFORMER. TO AVOID POSSIBLE
TRANSFORMER FAILURE DUE TO OVERCURRENT, USE A
TRANSFORMER THAT INCORPORATES THERMAL PROTECTION OR A
FUSE AT THE PRIMARY WINDINGS.
2.
WHEN USING WITH FLUORESCENT BALLASTS
,
BOTH LIGHTING
FIXTURE AND DIMMER MUST BE PROPERLY
GROUNDED.
3.
USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE. WITH
ALUMINUM WIRE USE ONLY DEVICES MARKED CO/ALR OR
CU/AL.
4.
DO NOT MIX LOAD TYPES ON A SINGLE ZONE (I.E, 120V TUNGSTEN
AND MAGNETIC LOW-VOLTAGE).
5.
DISCONNECT POWER WHEN SERVICING FIXTURES OR CHANGING
LAMPS.
TO INSTALL:
1.
WARNING:
TO AVOID FIRE, SHOCK, OR DEATH;
TURN OFF POWER
AT
CIRCUIT BREAKER OR FUSE AND TEST THAT POWER IS OFF BEFORE
WIRING!
2.
Determine location for installation of the Multizone Controller.
INSTALLATION INSTRUCTIONS
7
DI-000-D3206-00B
11/6/03, 10:59 AM
9
