µ-Dimension D3206, User Manual

Page: 22 / 48

NOTE: Two Channels cannot be mapped to the same Channel number.
You must first change the Channel to an “X”, which is a place holder
(i.e., to change 1 to 6, first change the 6 to an “X”, than change the 1 to
a 6. You may now change the 6 to a 1).
23. Press the Up or Down button to select the desired
TYPE (REL, DIM). This setting is used to select
either a dimming (dimmer) or a non-dimming
(relay) Load. If a dimmer (DIM) type is selected, press the
Select/Next
button to save entry and proceed. If a non-dimming (REL) type is
selected, press the
Select/Next button to save entry and proceed to
Step 25 .
24. Press the Up or Down button to select the desired
LOAD TYPE (FLOR, INC). This setting is used to
select either Incandescent, which is used for
Incandescent, Magnetic Low-Voltage, Cold Cathode, Tungsten and
Neon Loads or Fluorescent, which is used for Mark X™ Fluorescent
Loads. Press the
Select/Next button to save entry and proceed. Zone
programming is now finished.
25. If programming additional Zones, press the Select/Next button and
repeat Steps 18 through 24.
If Zone programming is complete, press the Wizards button to return to
the Main Screen.
NOTE: Programming of remote zones can be done from this device.
Aux Devices –
Used to set up LCnet address auxiliary devices.
26. Press the Up or Down button to select the Aux
Devices screen. Press the Select/Next button to
save entry and proceed.
27. Press the Up or Down and Left or Right buttons
to assign which panel that will control the auxiliary
device. Press the
Select/Next button to save entry
and proceed.
NOTE: The auxiliary device must have a different panel and zone than
any of the D3200 controllers that are on the network.
28. SET AUXILIARY DEVICE (refer to the specific
auxiliary device Instruction Sheet for details). Press
the
Select/Next button to save entry and return to
the Setup Wizard.
NOTE: This panel must be included on the Multizone Controller you wish
to control the auxiliary device from.
System – Used for factory representative to restore factory default
settings.
PROGRAMMING AND OPERATION
20
B
B
A
LOAD TYPE: <INC>
ZONE# 31-1
SELECT TYPE: DIM
ZONE# 31-1
B
A
Use , v or SEL
4> Aux Devices
V
PANEL: 01 ZONE:1
ZONE # 01-1
SET AUX DEVICE
SEL to Continue
DI-000-D3206-00B 11/6/03, 10:59 AM 22