TTC T-BERD 107A, Reference Manual

Page: 101 / 261

4-4
SECTION 4
AUXILIARY
FUNCTIONS
The AUX USER1, AUX USER2, and AUX
USER3 functions allow three user-defined 3- to 24-bit
patterns to be programmed. These patterns are trans-
mitted when USER1, USER2, or USER3 is selected
with the
PATTERN switch. Each pattern is transmit-
ted from left to right as it is displayed. The factory
default settings are 010100100 for the AUX USER1
function, 001101110 for the AUX USER2 function,
and 110001110 for the AUX USER3 function.
Use the following procedure to change the pat-
tern setting.
1. AUX and PATTERN switch
Press the AUX switch to activate the auxiliary
functions. Press the PATTERN switch to se-
lect the AUX USER1 function, AUX USER2
function, or AUX USER3 function.
2. CATEGORY switch
Press the up or down arrow to move the
cursor (blinking bit) to the bit to be toggled.
The up arrow moves the cursor forward
(FWD) from left to right. The down arrow
moves the cursor in the reverse (REV) direc-
tion from right to left.
3. RESULTS switch
Press the up arrow to toggle the selected bit
(blinking digit) between “1” and “0”.
4. CATEGORY and RESULTS switches
Repeat Steps 2 and 3 until the desired bit
pattern is complete. Move to the last bit of
the pattern.