Tsuruga 8527, Instruction Manual

Page: 52 / 112

52
15. External control
15.1
●
Control by REMOTE/OUT connector
By means of the
REMOTE/OUT
connector on the rear panel, the remote control of
start/stop, the setting of interlock to secure the safety, and the output signals corresponding
to each condition of the
8527
can be output by open collector.
The input and output signals are isolated from the internal circuit by photo-coupler.
Also, the
8527
is provided with the power source of 24V DC 0.1A, which can be utilized
as power supply for the external control.
15.2
●
Arrangement and function of connector pins
I/O Signal name Pin No. Function
+24V 1
Power 24V DC for external control is output.
(capacity 0.1A)
I
REAR:ON 2
Change-over signal for remote control.
Ref. article 14.3 for detail.
START 3 Input signal for start.
STOP 4 Input signal for stop.
INTERLOCK 5 Signal for interlock.
MEM SET 1 6
BCD code input for read out of memory.
(effective at the setting of REAR:MODE)
Effective for No.1~No.9
A~F code are ineffective, no memory can be read.
MEM SET 2 7
MEM SET 4 8
MEM SET 8 9
O
TEST/H.V.OUT 10
Output at high voltage terminal during the voltage
output.
READY 11 Output at READY status.
PROTECTION 12
Output when the protective function works.
Ref. article 15.4 for detail.
GOOD 13 Output at good judgement.
W HIGH 14 Output at NG judgement for high limit of W test.
W GOOD 15 Output at good judgement of W test.
I HIGH 16 Output at NG judgement for high limit of I test.
I GOOD 17 Output at good judgement of I test.
- NC 18 Vacant pin (do not use it as relay terminal).
COM COM 19 Common (common with 23, 26)
I
REAR:MODE 20
Change-over action of test mode (W, I) from the
rear panel.
W-MODE 21
Setting of mode for W test
(effective at the setting of REAR:MODE).
I-MODE 22
Setting of mode for I test
(effective at the setting of REAR:MODE).
COM COM 23 Common (common with 19, 36)
O
W-TEST 24
Output during the W test,
not output while
W-TEST is blinking.
I-TEST 25
Output during the I test,
not output while
I-TEST
is blinking.
TEST 26
Output during the test,
not output while
W-TEST
or
I-TEST
is blinking.
- NC 27 Vacant pin (do not use it as relay terminal).
O END 28 Output at the end of test.
-
NC 29 Vacant pin (do not use it as relay terminal).
NC 30 Vacant pin (do not use it as relay terminal).
O
NG 31 Output at NG judgement.
W LOW 32 Output at NG judgement for low limit of W test.
- NC 33 Vacant pin (do not use it as relay terminal).
O I LOW 34 Output at NG judgement for low limit of I test.
- NC 35 Vacant pin (do not use it as relay terminal).
COM COM 36 Common (common with 19, 23)
Type of input/output:
I: input
O: Open collector output.
COM: Common for input/output
- : Vacant pin