TSE DPT60, Owner'S Manual

Page: 292 / 459

63
Series 90 Minor Repair Instructions
Install Drive Coupling Install Alignment Pin in
Cover (CCW rotation shown)
90000298 90000297
Install Auxiliary Pad Adapter
Screws
Torque Pad Adapter Screws
90000305 90000281
Install O-ring on End Cap
Pilot
Install Auxiliary Pad Adapter
90000303 90000302
Install New Charge Pump
Cover
Install Screws and Cover
Retainer
90000300
90000299
7. Install the charge pump cover retainer and the six hex
screws and torque the screws.
e z i S e m a r F e u q r o T
0 0 1 - 0 3 0 ) t f • f b l 0 1 ( m N 5 . 3 1
0 5 2 - 0 3 1 ) t f • f b l 4 2 ( m N 2 3
E 8 8 2 2 0 0 T
8. Install O-ring on end cap pilot.
9. Install the auxiliary mounting pad adapter on external
pilot on rear of end cap.
10. Install four new large screws and washers through
the mounting pad and end cap into the housing.
Torque per the accompanying table.
e z i S e m a r F e u q r o T
- 0 3 0
2 4 0 y l r a e
) t f • f b l 3 4 ( m N 8 5
2 4 0 e t a l ) t f • f b l 0 9 ( m N 2 2 1
5 5 0 ) t f • f b l 0 9 ( m N 2 2 1
0 0 1 - 5 7 0 ) t f • f b l 9 8 1 ( m N 6 5 2
0 3 1 - 0 0 1 ) t f • f b l 0 2 2 ( m N 8 9 2
0 5 2 - 0 8 1 ) t f • f b l 9 2 4 ( m N 0 8 5
E 0 9 2 2 0 0 T
11. Install the O-ring and flange cover or auxiliary pump.
Auxiliary Pad Conversion
To convert an auxiliary mounting pad to a different size
mounting pad, use the above procedure with the following
additions:
After removing the charge pump cover (step 2), remove
the old auxiliary drive coupling.
After removing the four end cap retaining screws, remove
the old auxiliary mounting pad adapter.
Caution
In order to avoid loss of charge pressure in pumps
with an auxiliary mounting pad, always install the
charge pump cover with the pad drain hole lo-
cated on the same side of the end cap as the
charge inlet port. Refer to the section "Auxiliary
Pad Installation" for details.
S000 020E
6. Carefully remove the alignment pin from the charge
pump parts. Install the pin in its hole in the new
charge pump cover (with hole for the auxiliary cou-
pling) and retain with petroleum jelly. Install the new
charge pump cover with alignment pin into the end
cap and the aligned charge pump parts.