TSE DPT60, Owner'S Manual

Page: 118 / 459

Lubrication & Maintenance — 500 Hours/12 Months
Continued on next page ZE59858,0000017 -19-11AUG14-1/2
Changing Engine Oil and Replacing Filter
IMPORTANT: Changing engine oil and filter every
500 hours or 12 months depends on the
following requirements:
•
Engine equipped with an oil pan that allows
capacity for this extended drain interval.
•
Use of premium oil John Deere Plus-50,
API CJ-4, ACEA E9, or ACEA E6.
•
Perform engine oil analysis to determine
the actual extended service life of API CJ-4,
ACEA E9, or ACEA E6 oils.
•
Use of the approved John Deere oil filter.
•
Use of Ultra Low Sulfur Diesel (ULSD)
fuel with sulfur content less than 0.0015%
(15 mg/kg) is required.
The oil and filter change interval is reduced
if ANY of the above listed requirements
are not followed.
NOTE: During the initial operation of a new or rebuilt
engine with Break-In Plus, change the oil and
filter between a minimum of 100 hours and a
maximum of up to 500 hours.
NOTE: Service intervals depend on sulfur content of the
diesel fuel, oil pan capacity, engine power, and
the oil and filter used. For more information, see
Diesel Engine Oil and Filter Service Intervals in
the Fuels, Lubricants, and Coolants Section.
OILSCAN™ or OILSCAN PLUS™ is a John Deere
sampling program to help you monitor machine
performance and identify potential problems before they
cause serious damage. OILSCAN™ and OILSCAN
PLUS™ kits are available from your John Deere engine
distributor or servicing dealer. Oil samples should be
taken prior to the oil change. Refer to instructions
provided with kit.
RG26252
—UN—30JUL14
Oil Filter
A—Oil Filter B—Oil Pan Drain Plug
IMPORTANT: Engine oil and metal surfaces of engine
may be hot to the touch after shutdown.
Use care to prevent burns.
1. Run engine approximately 5 minutes to warm up oil.
Shut engine off.
NOTE: Drain plug location may vary, depending
on the application.
2. Remove oil pan drain plug (B).
3. Drain crankcase oil from engine while warm.
4. Install oil pan drain plug with a new O-ring and tighten
to specifications.
Specification
Oil Pan Drain Plug
(Stamped Steel
Pan)—Torque............................................................... 40 N·m (30 lb.-ft.)
Oil Pan Drain Plug (Cast
Pan)—Torque............................................................... 48 N·m (35 lb.-ft.)
OILSCAN is a trademark of Deere & Company.
OILSCAN PLUS is a trademark of Deere & Company.
40-3 032015
PN=71