TSE DPT60, Owner'S Manual

Page: 28 / 459

Figure 9- Drive Arm/Lifting Loop in Vertical Position
ALWAYS MAKE SURE THAT THE REEL IS PUSHED TIGHT AGAINST THE DRIVE
ARM AND HELD SECURELY BY LIFTING LOOP/LOCKING COLLAR
7. Install Bronze bearing on end of reel shaft.
8. Attach lifting hooks to Drive Arm and Lifting Loop, and ensure they are balanced so
reel remains level during lift.
9. Lower reel in place engaging reel shaft drive with mating part, and ensure Bronze
Bearing is located in Bearing Support.
10. Push reel shaft Pin into end of reel shaft at Drive Arm end, and insert Ball Lock Pin
to hold the Reel Shaft Pin in place.
11. At Lifting Loop end, swing Locking Latch into place over Bronze Bearing, and
insert Safety Pin.
! CAUTION/WARNING!
THE REEL MUST BE ‘OVERWOUND’ WHEN PLACED IN THE MACHINE AS
VIEWED FROM THE OPERATORS POSTION. THE REEL SHAFT DRIVE ARM
MUST BE INSERTED FROM THE SIDE OF THE REEL THAT WOULD TEND TO
WIND IN THE PULLING ROPE.
Figure 10- Reel Winding