4
Load Cell Connections
Connect your shielded load cell cable to terminal block J1 using the table below.
All terminals
are labeled for function.
TIP:
You should have the color codes handy for your load cell / junction box / weighing platform
before doing so.
Load Cell Terminal Block J1
Marking
Function
Marking
Function
GND
Shield
S-
- Signal
E+
+ Excitation
SE-
- Sense
SE+
+ Sense
E-
- Excitation
S+
+ Signal
NOTE1
: Use F11 to configure for 4-wire or 6-wire load cells
NOTE2
: Pins 1 and 2 are for DC power input (V+ and V
– respectively) …
NOTE3
: There are two configurations for J1, as shown above, and differing only in the location
of the load cell shield wire connection (GND)
