Toyota Celica 2005, Repair Manual

Page: 2466 / 2497

AC3SA − 01
I13000
Bolt A
Bolt C
Bolt B
H23741
Bolt A
Bolt B Bolt B
Bolt C
Push
AC − 42
− AIR CONDITIONING COMPRESSOR AND MAGNETIC CLUTCH
2005 CELICA (RM1131U)
INSTALLATION
1. INSTALL COMPRESSOR
(a) Install the compressor with 3 bolts.
(b) Temporarily tighten bolt A.
HINT:
Do not over tighten the bolt until the compressor no longer
moves.
(c) Push down on the rear side of the compressor and fully
tighten bolt B, bolt C and bolt A in order.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(d) Connect the compressor connector.
2. CONNECT DISCHARGE AND SUCTION HOSES
(a) Lubricate 2 new O − rings with compressor oil and install
them to the hoses.
(b) Connect the both hoses with 2 bolts.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
NOTICE:
Hose should be connected immediately after the caps have
been removed.
3.
1ZZ − FE:
INSTALL CRUISE CONTROL ACTUATOR (See page
CO
− 30)
4. 2ZZ − GE:
INSTALL AIR PUMP ASSEMBLY (See page CO − 30)
5. INSTALL AND CHECK DRIVE BELT
(See page AC
− 18, AC − 16)
6. CONNECT NEGATIVE ( − ) TERMINAL CABLE TO BAT-
TERY
7. EVACUATE AIR FROM REFRIGERATION SYSTEM
AND CHARGE SYSTEM WITH REFRIGERANT
Specified amount: 430
± 30 g (15.17 ± 1.06 oz.)
8. INSPECT FOR LEAKAGE OF REFRIGERANT
(a) Using a gas leak detector, check for leakage of refriger-
ant.
If there is leakage, check the tightening torque at the joints.
9. INSPECT A/C OPERATION
2465