Toyota Celica 2005, Repair Manual

Page: 2075 / 2497

F08475
Inscribed Mark
F08476
F08804
Compressed Air
F08478
Inscribed Mark
Inscribed Mark
− STEERING POWER STEERING VANE PUMP
SR − 29
2005 CELICA (RM1131U)
If it is more than the maximum, replace the vane plate and/or
vane pump rotor with the one having the same mark stamped
on the cam ring.
Inscribed mark: 0, 1, 2, 3, or 4
HINT:
There are 5 vane plate lengths corresponding to the following
vane pump rotor and cam ring marks:
Vane pump rotor and
cam ring mark
Vane plate part
number
Vane plate length
mm (in.)
0 44345 − 32100
12.001 − 12.003
(0.47248 − 0.47256)
1 44345 − 32110
11.999 − 12.001
(0.47240 − 0.47248)
2 44345 − 32120
11.997 − 11.999
(0.47232 − 0.47240)
3 44345 − 32130
11.995 − 11.997
(0.47224 − 0.47232)
4 44345 − 32140
11.993 − 11.995
(0.47216 − 0.47224)
3. INSPECT FLOW CONTROL VALVE
(a) Coat the flow control valve with power steering fluid and
check that it falls smoothly into the valve hole of the front
housing by its own weight.
(b) Check the flow control valve for leakage. Close one of the
holes and apply compressed air of 392
− 490 kPa (4 − 5
kgf/cm
2
, 57 − 71 psi) into the opposite side hole, and con-
firm that air does not come out from the end hole.
If necessary, replace the flow control valve with the one having
the same letter as inscribed on the front housing.
Inscribed mark: A, B, C, D, E or F
2074