Toyota Celica 2005, Repair Manual

Page: 2097 / 2497

F09894
Rack Groove
F09895
Fulcrum
Length
SST
F09896
Brass Bar
F09897
F09924
− STEERING POWER STEERING GEAR
SR − 51
2005 CELICA (RM1131U)
11. INSTALL RH AND LH CLAW WASHERS AND RACK
ENDS
(a) Install a new claw washer, and temporarily install the rack
end.
HINT:
Align the claws of the claw washer with the steering rack
grooves.
(b) Using a spanner, hold the steering rack steadily and using
SST, torque the rack end.
SST
09922 − 10010
Torque: 62 N·m (630 kgf·cm, 46 ft·lbf)
NOTICE:
Use SST 09922
− 10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 380 mm (14.96
in.).
(c)
Using a brass bar and a hammer, stake the washer.
NOTICE:
Avoid any impact on the steering rack.
(d) Employ the same manner described above to the other
side.
12. INSTALL RH AND LH RACK BOOTS, WIRES AND
CLIPS
(a) Ensure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel is turned.
(b)
Install the boot, clip and a new wire.
NOTICE:
Be careful not to damage or twist the boot.
(c) After winding and tightening the wire around the circum-
ference of the boot twice, twist it several times, and install
it.
2096