Toyota Celica 2005, Repair Manual

Page: 631 / 2497

DI − 432
− DIAGNOSTICS ENGINE (2ZZ − GE)
2005 CELICA (RM1131U)
TYPICAL ENABLING CONDITION
Item
Specification
Minimum Maximum
The monitor will run whenever this DTC is
not present
See page DI − 295
Time after following conditions are met: 50 sec. −
Engine coolant temperature 40
_
C (104
°
F) −
Engine RPM 1,400 rpm −
Vehicle speed 40 km/h (25 mph) −
Idle OFF
Time after engine start 180 sec. −
TYPICAL MALFUNCTION THRESHOLDS
Detection Criteria Threshold
Front heated oxygen sensor voltage Less than 0.45 V
COMPONENT OPERATING RANGE
Parameter Standard value
Front heated oxygen sensor voltage in the normal condition 0 to 1 V
WIRING DIAGRAM
Refer to DTC P0130 on page DI − 411.
INSPECTION PROCEDURE
HINT:
Hand
− held tester only:
To determine the trouble area is possible by performing ”A/F CONTROL” ACTIVE TEST (heated oxygen
sensor or other trouble areas can be distinguished).
(a)
Perform ACTIVE TEST using the hand − held tester (A/F CONTROL).
HINT:
”A/F CONTROL” is the ACTIVE TEST which changes the injection volume to
− 12.5 % or +25 %.
(1) Connect the hand − held tester to the DLC3 on the vehicle.
(2) Turn the ignition switch ON.
(3) Warm up the engine by running the engine at 2,500 rpm for approximately 90 seconds.
(4) Select the item ”DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST / A/F CONTROL.
(5) Perform ”A/F CONTROL” with the engine idling (press the right or left button).
RESULT:
Heated oxygen sensor reacts in accordance with increase and decrease of the injection volume
+25 %
→ rich output: More than 0.5 V,
− 12.5 % → lean output: Less than 0.4 V
630