Toyota Celica 2005, Repair Manual

Page: 2374 / 2497

H12610
Adhesive
b − b
a − a
c − c
Adhesive
Adhesive
c
b b
a
a
c
A
A
A
B
B
B
H12669
BO − 68
− BODY BACK DOOR GLASS
2005 CELICA (RM1131U)
(c) Coat the glass with adhesive as shown in the illustration.
A: 12.0 mm (0.472 in.)
B: 8.0 mm (0.315 in.)
8. INSTALL BACK DOOR GLASS
(a) Install the back door glass to the back door.
HINT:
Confirm that the dams is attached to the back door panel.
(b)
Hold the back door glass in place securely with a protec-
tive tape or equivalent until the adhesive hardenes.
NOTICE:
Take care not to drive the vehicle during the time described
in the table below.
Temperature Minimum time prior to driving the vehicle
35 ° C (95 ° F) 1.5 hours
20 ° C (68 ° F) 5 hours
5 ° C (41 ° F) 24 hours
9. INSPECT FOR LEAKS AND REPAIR
NOTICE:
Conduct a leak test after the hardening time has elapsed.
10. INSTALL BACK WINDOW OPENING TRIM
11.
INSTALL CENTER STOP LIGHT
12. INSTALL BACK DOOR TRIM BOARD
13. INSTALL DOOR PULL HANDLE
14. INSTALL REAR WIPER ARM
(a) Operate the wiper motor once and turn the wiper switch
OFF.
(b) Install the rear wiper arm and tighten the nut by hand.
(c) Adjust the installation position of the wiper arm at a point
in defogger pattern.
(d) Tighten the nut.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
15. w/ Rear spoiler:
REMOVE REAR SPOILER
2373