Toshiba Strata CT, Installation & Maintenance Manual

Page: 176 / 385

Station Apparatus
5-20
Strata CT I&M Manual October 2000
7. Connect the HHEU subassembly wire plug to the P1 connector on the electronic
telephone PCB.
8. Cut the HHEU strap on the telephone PCB.
Note
The HHEU strap must be replaced if the HHEU PCB is removed from the
telephone.
9. Reinstall the telephone base, and secure it with its four captive screws.
Adjust (HESB) Loud Ringing Bell Volume
1. Call the telephone connected to the HESB.
2. Adjust the volume control on both the back of the HESB and the ring volume control on
the telephone.
Carbon Headset/Handset Straps
If a carbon-type handset or headset is connected to the handset jack on the side of the 6500-
series electronic telephone, two straps inside the telephone must be cut.
➤
To cut the straps
Note It is not necessary to cut these straps if the headset is connected to the HHEU.
See Figures 5-1 and 5-11 and follow these steps:
1. Loosen the four captive screws on the telephone base and remove the base.
2. Locate the carbon straps, W201 and W202 and cut them.
3. Reinstall the telephone base, and secure it with its four captive screws.
Beep Strap
A “beep” sounds whenever a dial pad button or feature button is pressed on an electronic
telephone.
➤
To eliminate the beep
See Figures 5-1 and 5-11 and follow these steps:
1. Remove the four captive screws on the telephone base to the telephone and remove the
base.
2. Locate and cut the beep strap on the telephone PCB.
3. Reinstall the electronic telephone base and secure in place using the four captive screws.
H
C