Toshiba Strata CT, Installation & Maintenance Manual

Page: 350 / 385

ISDN Interfaces
10-24
Strata CT I&M Manual October 2000
RPTU Performance Monitoring
The performance of the RPTU can be monitored using the Data Dump Mode. This requires:
◆
RSIU, RSIS, PIOU, PIOUS or TSIU PCB TTY port.
◆
ASCII terminal or PC with communications software (such as ProComm or
Hyperterminal).
◆
IMDU or RMDS modem or Hayes compatible modem for remote monitoring.
The RPTU monitoring feature provides a download of PRI errors detected as shown in
Figure 10-18 . This data can be stored to a file and/or printed when using a PC with
communications software.
There are no time parameters for the error report, so the time between error-count increments
must be monitored manually. The counter is reset after 15 registrations and begins again from
zero. Basically the error count of any error category should not increase within 24-hour
periods.
➤
To dump the data (PRI ERROR DISPLAY) from a terminal or PC (local or remote)
1. Establish communications between the CT TTY port and the terminal or PC using a
communications software.
2. Enter the security code, and press
Enter
(or
Return
).
3. At the
>MODE
prompt, type
DUMP
(must be all caps), and press
Enter
(or
Return)
.
The >D prompt displays on your screen.
4. At the >D prompt, type PRIERR and press Enter (or Return ). The display (see
Figure 10-18 ) shows all RPTU PCBs (PRI NO=1~PRI NO=8), even if the associated
RPTU (1~8) is not installed. The ERROR counter can only be reset by turning the CT
Off and On.
➤
To exit the dump mode
➤
At the >D prompt, type QUIT , press Enter (or Return ); the >MODE prompt
displays.
H
C