Toshiba MMY-MAP0806HT7(J)P, Service Manual

Page: 261 / 350

[When replacing normal as well as faulty compressor] - applicable to MMY-
MAP 14A6 ∗ ,
16A6 ∗ , 1806 ∗ , 2006 ∗ and 2206 ∗
<
Remove the
normal compressor>
•
Remove the
normal compressor in the same way as the faulty compressor.
Note:
• Be sure to insulate the removed compressor leads using insulation tape, etc.
WARNING
When detaching a pipe by heating with a burner
at brazed
joint, take care as any oil left in the piping may burn in
a momentary flash of fire when the
brazing
filler metal melts.
<Measuring amounts of oil in normal compressors>
• As was the case with the faulty compressor, measure the amount of oil contained by placing each compressor
on a scale.
Amount of oil in normal compressor: B [cc] = (Weight of compressor as it was dismantled (kg) - D) × 1042
(Specific volume of oil: 1042 [cc/kg])
Note:
(kg)
Compressor model
RA641A3TB-20M
2
4
.
5
※
Please check the type name of the compressor as it was dismantled.
<Adjusting amount of oil in new compressors>
• Perform the adjustment on the basis of how much oil the faulty compressor contained, A [cc], and how much oil
the normal compressor contained, B [cc], by following the steps below.
1
Combined amount of oil in faulty compressor and normal compressor A+B [cc]: 0
≤
A+B <
2
000
(1) Adjust the amount of oil in the
two
new compressor to 1000cc each (total
2
000cc).
• Lay the compressor down and draw 900 [cc] of oil from each of them via their oil equalization pipes.
Notes:
• Do not draw more than 900 [cc] of oil from a compressor as it may cause damage.
• If the faulty compressor contained 500cc or less, there may have been a problem with the oil equalization circuit,
etc. Perform checks in accordance with “11-3. Check Procedure to Search Cause of Compressor Oil Shortage”.
2
Combined amount of oil in faulty compressor and normal
compressor A+B [cc]:
2
000
≤
A+B <
5300
(1) Adjust the amount of oil in the
two
new compressor to (A+B)/
2
cc each.
• Lay the compressor down and draw [5
3
00-(A+B)]/
2
[cc] of oil from each of
them via their oil equalization pipes.
3
Combined amount of oil in faulty compressor and normal
compressor A+B [cc]:
53
00
≤
A+B
(1) Adjust the amount of oil in the
two
new compressors to (A+B)/
2
cc each.
(Insert a hose into the discharge pipe or oil equalization pipe of each
compressor and inject (A+B)/
2
-1900 [cc] of oil using a funnel, etc.)
Compressor
Ｄ：
Weight
(
not include oil
）
− 2 60 −