Toro Multi Pro 1750, Operator'S Manual

Page: 27 / 76

inside the filter head) for damage and wear
(
Figure 15 ).
Important:
Replace any damaged or worn
gaskets for the plug, bowl, or both.
8. Install the pressure filter element into the filter
head (
Figure 15 ).
Note:
Ensure that the filter element is firmly
seated into the filter head.
9. Install the bowl onto the filter head, and tighten
by hand (
Figure 15 ).
10. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(
Figure 15 ).
Cleaning the Nozzle Filter
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Remove the nozzle from the spray turret ( Figure
16 ).
g209504
Figure 16
1. Spray turret 3. Nozzle
2. Nozzle filter
3. Remove the nozzle filter ( Figure 16 ).
4. Clean the nozzle filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
5. Install the nozzle filter ( Figure 16 ).
Note:
Ensure that the filter is fully seated.
6. Install the nozzle onto the spray turret ( Figure
16 ).
Inspecting the Tank Straps
Service Interval: Before each use or daily—Check
the tank straps.
Important:
Overtightening the tank strap
fasteners can result in deforming and damaging
the tank and straps.
1. Fill the main tank with water.
2. Check to see if there is any movement between
the tank straps and the tank (
Figure 17 ).
g028263
Figure 17
1. Rear tank strap 4. Forward tank strap
2. Bolt 5. Front of the machine
3. Flanged locknut
3. If the tank straps fit loose to the tank, tighten the
flanged locknuts and bolts at the top of straps
until the straps are flush with the surface of the
tank (
Figure 17 ).
Note:
Do not overtighten the tank strap
hardware.
27