Toro Multi Pro 1750, Operator'S Manual

Page: 33 / 76

pressure reading on the gauge is 6.9 bar (100
psi).
g028049
Figure 20
1. Agitation-bypass valve 2. Master-section bypass
12. Press the pump switch to the O
FF
position, shift
the throttle lever to the I
DLE
position, and turn
the ignition switch to the O
FF
position.
Adjusting the
Master-Section-Bypass
Valve
Note:
Adjusting the master-section-bypass valve
reduces or increases the amount of flow sent to the
agitation nozzles in the tank when the master-section
switch is set to the O
FF
position.
1. Fill the sprayer tank 1/2 full with clean water.
2. Move the machine to an open level surface.
3. Set the parking brake.
4. Set the range selector to the N
EUTRAL
position.
5. Set the pump switch to the O
N
position.
6. Set the agitation switch to the O
N
position.
7. Set the master-section switch to the O
FF
position.
8. Increase the engine speed to full throttle and set
the throttle lock to the O
N
position.
9. Adjust the master-section-bypass handle to
control the amount of agitation occurring in the
tank (
Figure 20 ).
10. Reduce the throttle speed to idle.
11. Set the agitation switch and pump switch to the
O
FF
position.
12. Shut off the machine.
Locating the Spray Pump
The spray pump is located under the seat ( Figure 21 ).
g216323
Figure 21
Hauling the Machine
•
Use full-width ramps for loading the machine onto
a trailer or truck.
•
Tie the machine down securely.
Transporting the Sprayer
When moving the sprayer long distances, use a trailer.
•
Secure the sprayer to the trailer.
– Use the tie-down loop at the front of the frame;
refer to Figure 22 A.
– Use the 2 tie-down loops at the rear of the
frame; refer to Figure 22 B.
•
Ensure that the outer-boom sections are tied down
and secure.
33