Toro Multi Pro 1750, Operator'S Manual

Page: 14 / 76

Setup
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Anti-Siphon
Fill Receptacle
Parts needed for this procedure:
1 90° fitting
1 Quick coupler
1 Hose adapter
1 Fill-receptacle bracket
1 Flange-head bolt (5/16 x 3/4 inch)
1 Anti-siphon hose
Procedure
1. Place the fill-receptacle bracket over the
threaded hole in the tank and secure it with a
flange-head bolt (5/16 x 3/4 inch) as shown in
Figure 3 .
g001488
Figure 3
1. Fill-receptacle bracket 5. Quick coupler
2. Threaded hole in the tank 6. Hose adapter
3. Flange bolt (5/16 x 3/4
inch) 7. Anti-siphon hose
4. 90° elbow fitting
2. Place the threaded end of the 90° elbow fitting
through the bracket and thread the quick coupler
onto it, securing it to the bracket (
Figure 3 ).
Note:
Install the fitting with the open end
pointing toward the large opening in the bracket
and toward the tank opening so that the water
arcs into the tank when you fill it.
3. Install the hose adapter into the quick coupler
(
Figure 3 ).
4. Lock the adapter into place by swinging the
levers toward the adapter and then secure them
with the hairpin cotters (
Figure 3 ).
5. Install the anti-siphon hose through the large
opening on the bracket and onto the barbed end
of the 90° elbow fitting (
Figure 3 ).
Important:
Do not lengthen the hose to
allow contact with the tank fluids.
2
Checking the Section-Hinge
Springs
No Parts Required
Procedure
Important:
Operating the spray system with
the section-hinge springs under the incorrect
compression could damage the boom assembly.
Measure the springs and use the jam nut to
compress the springs to 3.96 cm (1.56 inches) if
necessary.
The sprayer is shipped with the section extensions
swung forward to facilitate shipping the machine.
The springs are not fully tightened at the time of
manufacture to allow the sections to be in this position
for transit. Before operating the machine, the springs
must be adjusted to the correct compression.
1. If necessary, remove the packing components
that secure the right and left extension sections
during shipping.
2. Support the sections while they are extended to
the spray position.
3. At the section hinge, measure the compression
of the upper and lower springs while the sections
are in their extended position (
Figure 4 ).
14