Multifunction Switch (Optional)
POSITION
CLOSED
CIRCUITS
ALL OFF
NONE
HORN
4 + 8
ROAD
LIGHTS
1 + 9
WORK
LIGHTS
3 + 9
ROAD and
WORK
LIGHTS
1 + 3 + 9
TURN
SIGNALS
(Turn
Right)
2 + 6
TURN
SIGNALS
(Turn Left)
2 + 7
The multifunction switch is used to control the optional work lights, road lights,
turn signals, and horn. The switch is located in the optional steering column
control pod.
Testing the Multifunction Switch
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
FF
position and remove
the key from the key switch.
2. Disconnect the battery negative (-) cable at the battery; refer to
and Installing the Battery (page 6–64)
.
3. To access the switch, remove the cover from the steering column control pod.
4. Disconnect the machine wire harness connector from the multifunction
switch. Check the switch and the harness connector for damage or corrosion
and clean or repair if necessary.
5. Use a multimeter (ohms setting) and the preceding table to determine
whether continuity exists between the various terminals for each switch
position.
6. Replace the switch if testing determines that the switch is damaged.
7. If the switch testing is correct and a circuit problem still exists, check the wire
harnesses; refer to
Appendix A (page A–1)
.
8. After you complete the testing, connect the machine wire harness connector
to the switch and install the control pod cover.
Electrical System: Testing the Electrical Components
Page 6–40
Groundsmaster
®
3200, 3300 and 3310
19240SL Rev A
Summary of Contents for Groundmaster 31900
