Toro Groundmaster 31900, Service Manual

Page: 307 / 355

Rollers and Skids
g315280
Figure 140
1. Lock nut 5. Spacer 9. Skid/bumper
2. Roller
6. Spanner 10. Flange nut (2 each)
3. Spanner 7. Cap screw
4. Cap screw 8. Carriage screw (2 each)
Removing and Installing the Rollers and Skids
Refer to Figure 140 for this procedure.
1. Park the machine on a level surface, lower the cutting unit, engage the
parking brake, set the key switch to the O
FF
position and remove the key
from the key switch.
2. To preserve the roller or skid height, record the mounting hole locations and
remove the rollers or skids from the cutting unit as necessary.
3. Install the rollers or skids in the mounting holes previously recorded. Tighten
the roller fasteners so the screw threads fully engage the nylon insert of the
lock nut while allowing the roller to rotate freely.
Groundsmaster ® 3200, 3300 and 3310 Page 8–15 Cutting Units: Service and Repairs
19240SL Rev A