Removing the Lift Cylinder (continued)
9. If the hydraulic fittings are to be removed from the cylinder, mark the fitting
orientation for assembly purposes and remove the fittings from the cylinder.
Discard the O-rings from the fittings.
Installing the Lift Cylinder
Refer to
for this procedure.
1. If the hydraulic fittings were removed from the cylinder, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
Installing the Hydraulic Fittings
(SAE Straight Thread O-Ring Fittings) (page 5–9)
.
2. Remove the caps and plugs then connect the hydraulic tubes to the cylinder
fittings; refer to
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal
.
3. Install the pivot pin securing the rod end of the cylinder to the lift arm.
4. Install the nylon washers, pivot bolt, and nut securing the barrel end of the
cylinder to the frame.
5. Lubricate the cylinder pivot grease fittings.
6. Operate the lift cylinder. Check for hydraulic leaks and correct if necessary.
7. Install the step if previously removed.
8. Install the front wheel; refer to
Removing and Installing the Wheels (page
.
9. Check the hydraulic fluid level and adjust if necessary before returning the
machine to service.
Groundsmaster
®
3200, 3300 and 3310
Page 5–103
Hydraulic System: Service and Repairs
19240SL Rev A
Summary of Contents for Groundmaster 31900
