- 50 -
○Tightening procedure when auto start mode is OFF
① When
is not displayed, press
SET● button to display
.
NOTE The window reads
for approx 0.5
second while
“
Zero adjustment
”
is automatically
performed (See Page)
CAUTION Before starting “Zero point adjustment”
by pressing SET ● button, check the
reaction bar for no loading.
②Tighten the bolts/nuts with
POWER DIGITORQON.
③ As POWER DIGITORQON stops, the maximum
tightening torque measured during tightening
procedure is displayed. To continue the
measurement, repeat procedure with step 1).
NOTE For tightening operation, refer to section 6. Operating procedure (pp. 25-29).
NOTE When microSD memory card is installed, the tightening torque value is saved to
“Group file” in the memory card (See Page 22)
NOTE When “Auto start mode” is
OFF, power saving message
will be
displayed after a given length of time.
NOTE When no operation has been attempted for more than 10 min. “Automatic power
off function” turns off power (See Page 20).
CAUTION
When a tightening torque exceeding the maximum torque that can be
displayed on POWER DIGITORQON is measured, the window reads
（Error Over
Load）in place of the tightening torque, and accuracy of tightening torque reading cannot be
guaranteed (p.38).
