- 42 -
CAUTION
● Make sure press SET● button to show
each time
before next tightening when auto start is OFF .
Torque will not be measured if tightening operation is started without
displaying
.
● Never apply load before
is displayed.
Failure to follow this instruction results in inaccurate torque measurement.
● Never press SET● button when load is being applied.
Failure to follow this instruction results in inaccurate torque measurement.
●
（Error Over Load） will appear
when load is applied beyond maximum
torque of the wrench. Once
is
displayed, it will continue to show up every time when power is
turned on to give alert that measured torque cannot be
guaranteed.
●
Contact your distributor for repair and recalibration.
Failure to follow this instruction results in inaccurate torque measurement.
● Change batteries when
is
displayed. (see page 24)
