67
20.2.2. "Restart" Warning Display
If all of the connected hard disk drives experience an error, then
the warning message shown at right is displayed.
Press the power key continuously for two seconds or more to cut
the power, then press the key again to restart.
20.2.3. Checking Hard Disks When an Error Has Occurred
The hard disk that error has being occurred can be confirmed on
the hard disk initialization screen in the Menu display.
If a hard disk error occurs when hard disk drives are connected,
"-----" is displayed.
(Refer to
p. 102
; Hard disk drive initialization.)
Note
For the slave of HDD-A, "-----" is displayed, as the hard disk drive
is not connected to it. If HDD-B's master hard disk error occurs, it
may cause HDD-B's slave (DVD) error.
20.2.4. If a Hard Disk Error Occurs
If the disk drive is the Digital Video Recorder's:
• Restart the power.
Note
If the drive is restored by restarting the power, then some of the recorded data may be lost. Copy any
necessary data to another location and initialize the disk.
• If the error persists even after restarting the power, then initialize the disk.
Note
Initializing the disk will cause all video and other data stored on it to be erased.
Copy any necessary data on the hard disk, that the error has not occurred, to another location, and initialize
the disk.
• If the error persists even after the disk has been initialized, then it is necessary to replace the hard disk
drive. Consult your TOA dealer for more information.
A N
E R R O R
H A S
B E E N
D E T E C T E D
O N
T H E
H A R D
D I S K .
P L E A S E
R E A C T I V A T E
U S I N G
T H E
P O W E R
K E Y .
H D
I N I T I A L I Z E
D I S K
M O D E
N O R M A L
E X E C U T E
E X E C U T E
H D D – A
M A S T E R
G B
S L A V E
- - - - -
H D D – B
M A S T E R
- - - - -
S L A V E
D V D
N O R M A L
Error occurs
