Tippmann TIPX, Owner'S Manual

Page: 4 / 92

4
E
N
G
L
I
S
H
WARNING
Always keep the barrel blocking device installed except
when your marker is in use. Always make sure that the
trigger safety is in the safe mode (see instructions on
page 6) and the barrel blocking device is properly installed
on your marker according to the instructions to prevent
damage to property, serious injury, or death.
Barrel Blocking Device Installation Instructions
1. Insert the barrel blocking device into the barrel and loop the cord over the top of the
receiver and position at the back of the grip as shown.
2. Adjust the cord length
retainer up to the back of
the grip by pulling the cord
back while pushing the cord
length retainer toward the
marker. Ensure that the cord
length retainer is completely
tightened against the back of
the grip by pulling the cord
as tight as possible.
3. To remove barrel blocking
device, pull back on center
piece of cord length retainer
and slide retainer toward end of cord.
4. Before and after playing, inspect the barrel blocking device. Replace the barrel blocking
device if the cord is damaged or there is a loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
WARNING
This is not a toy. Misuse may cause serious injury or
death. Eye, face, and ear protection designed for paintball
must be worn by the user and any person within range.
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when
using this product. Read the Owner’s Manual before
using this product.
Barrel
Blocking
Device
Cord Length
Retainer