Tippmann TIPX, Owner'S Manual

Page: 14 / 92

14
E
N
G
L
I
S
H
Magazine Testing
1. Pull down on the Ball Carrier tabs until the Ball Carrier is about midway down the
Magazine.
2. While holding onto the Ball Carrier tabs, push down on the Carrier Release Armature
and ensure that the Magazine Ball Latch moves freely.
3. Release the Ball Carrier. The Ball Carrier should move freely when properly
reassembled.
4. Push the Ball Carrier all the way to the bottom of the Magazine until it locks into place.
5. Press down on the Carrier Release Armature to release the Ball Carrier.
Magazine testing is complete.
Marker Disassembly/Assembly
Set up a table with plenty of space to work to make sure no small parts become lost.
Eye protection must be worn during disassembly and reassembly. Do not disassemble a
pressurized paintball marker. Do not pressurize a partially assembled paintball marker. Follow
CO2 Cartridge Removal
instructions on page 10 (page 21 if a Remote Line Adapter is
installed), leave the CO2 cap (15) off.
1. For Remote Line equipped
markers, first remove the
Remote Line Adapter by
turning it counterclockwise
on the flats with a 1/2”
wrench, and pull it out.
(For reassembly, insert the
Remote Line Adapter into
the hole in the back of the
marker as shown. Carefully
hand start and screw it into
the air fitting until finger
tight.)
2. Remove the Barrel (27) by
turning it counterclockwise, and pull it out.
3. Remove the left-side receiver (2) by unscrewing the 7 receiver bolts (items 8, 9, and
10). Carefully lift the Left Receiver half to access the internal parts.
4. Lift out the CO2 Cap Receiver Insert (14), Barrel Shroud (26), and Barrel Adapter (25).
Lift out (as one piece) the Long Gas Line (19), Puncture Valve (7), Regulator (21), Air
Valve (23) (with Firing Valve
(items 45-51), and Short Gas
Line (20) assembly.
To separate this sub-
assembly, pull the Long
Gas Line (19) out of the two
integrated air fittings (12).
(At reassembly, lubricate
the Long Gas Line O-rings.)
Pull the Regulator (21)
from the Air Valve (23) and
pull out the Short Gas Line
(20) (lubricate O-rings at
reassembly). Remove the
NOTE: Carefully hand start all threaded parts and
do not overtighten and strip threaded parts when
reassembling.
14
26
25
12
12
23
7 . 19 21
20 46
NOTE:
Failure to reassemble
correctly can cause damage
to parts, air leaks, and other
problems. As you reassemble your marker, double check
to be sure parts are clean, not damaged, lubricated, and
installed correctly.
27
10
8 .
9 . 10
10
10
Remote Line
Adapter
26
15
4 .
2 .
10