Tippmann TIPX, Owner'S Manual

Page: 13 / 92

13
E
N
G
L
I
S
H
Magazine Reassembly
1. Place the Carrier Release Lever Spring into the
Right Shell.
2. Properly orient the Carrier Release Lever onto the
Carrier Release Lever Spring in the Right Shell.
3. Place the Magazine Ball Latch and Carrier
Release Armature into the Right Shell.
4. Set the Latch Spring between the Magazine Ball
Latch and the Carrier Release Armature. The
Latch Spring sets in a pocket formed by the two
parts inside the Right Shell.
5. Confirm that the Magazine Ball Latch and Carrier
Release Armature are oriented as shown in
the circled area at right. The flat surfaces of the
Magazine Ball Latch and the Carrier Release Armature fit together, and must align
correctly for the Magazine to operate properly.
6. Place the Ball Carrier Spring into the Right Shell.
7. Install the Left Shell onto the Right Shell, but do not fully press the two pieces together.
Be sure the internal parts stay in their locations while putting the two shell halves
together. The top hook (see arrow) of the Right Shell does not engage at this time.
8. Install the bottom #4 x 5/8 Screw. Tighten it until snug.
9. Place the Ball Carrier onto the Ball Carrier Spring (aligning the two tabs on the Ball
Carrier with the slots in the Left Shell and Right Shell) and slide down into the top of the
assembled shell halves. Push down on the Ball Carrier until it snaps into place inside
the Magazine.
10. Push the top of the Magazine together so the top hook engages (arrow below).
11. Install the three remaining #4 x 5/8 Screws. Tighten them until they are snug.
Magazine
Ball
Latch
Carrier Release Armature
Latch
Spring
#4 x 5/8 Screws
Left Shell
Ball
Carrier
Ball Carrier
Spring
Magazine
Ball Latch
Right Shell
Latch
Spring
Carrier
Release
Lever
Carrier Release
Lever Spring
Carrier
Release
Armature