THOR-SSM
Rev. : 02/09/2012
61
To set the jumper for powering the THOR Control External Switching Device, you need to
open the THOR Small Switch Device. To open the unit, unscrew the Philips screws at the
bottom of the device. Carefully remove the lower and upper shells of the case.
The jumper is located as shown in the following figure:
Plug the jumper on the two pins. Then close the devices and secure it by screws. Now you
can connect your THOR Control External Switching Device.
Fastening
screws on the
base
Fastening
screws on the
base
