THOMSON SpeedTouch 605, User Manual

Page: 144 / 212

Chapter 5
Expert Configuration
E-DOC-CTC-20050429-0104 v1.0
134
Configuration
The
Configuration
page allows you to configure IPQoS for a given destination
interface for the IPQoS queues instantiation.
Following settings are available:
Name
:
The destination interface for the IPQoS queues instantiation.
State
:
Disable or enable IPQoS for the interface.
Discard
:
Determines the packet discard strategy in case of congestion. Choose between:
tail
: Tail Drop: arriving packets will be dropped as soon as the destination
queue is in an overflow state.
early
: Early Packet discard: arriving packets will be dropped early
according to the BLUE active queue management algorithm.
Priority
:
Select the subqueue priority algorithm. Choose between:
wfq
:
Weighted Fair Queuing (WFQ) is used for the four AF queues. The realtime
queue has priority over the WFQ queues, which have priority over the
best-effort queue.
strict
:
Priority queuing is used. Strict Priority scheduling is used between all
queues. The higher the queue number, the higher the priority.
wrr
:
Weighted Round Robin (WRR) is used for the four AF queues. Each queue
is scheduled in turn, with a circular “round” wrapping.
WFQ queue Weight
:
A number between 1 and 97. Represents the weight of the queue used for
WFQ or WRR.
Max highest queue rate (%)
:
Represents a percentage of the interface bandwidth for rate-limiting of the Real
Time queue. In case of congestion, the Real Time queue will only use this
percentage of the interface bandwidth when there is also traffic on the other
queues. This prevents other queues from starvation (when the highest uses all
bandwidth).
Max highest queue burst
:
Represents the Real Time queue burst size (in kilobytes) for rate limiting.
When enabling or disabling IPQoS, take the following into account:
if the WAN interface (for example PPPoA, IPoA,...) is detached at the
time of enabling/disabling IPQoS, then the WAN interface has to be
attached in order for the enabling/disabling of IPQoS to take effect.
if the WAN interface is attached at the time of enabling/disabling
IPQoS, then the WAN interface has to be detached and then re-
attached in order for the enabling/disabling of IPQoS to take effect.