MOTOR DRIVE FOR 2-PANEL GATES - CONNECT
EN
6
www.mythomson.com
A - SAFETY INSTRUCTIONS
In our efforts to continually improve our products,
we reserve the right to make any changes to the
technical, functional, or aesthetic characteristics
related to their development.
This motorised gate, and its manual, were
designed to enable a gate to be motorised in
compliance with current European standards.
WARNING
Important safety instructions. A motorised gate
is a product that can cause injury to people and
animals and damage to property. It is important
for people’s safety to follow these instructions
and keep them.
1 - OPERATING PRECAUTIONS
• This apparatus may be used by children over the
age of 8 and by persons with reduced physical,
sensory or mental abilities or lack of experience
or familiarity, if they are correctly supervised
or if the instructions relating to the safe use
of the apparatus have been given to them and
the possible hazards are understood. Children
must not play with the device. Keep the remote
controls out of the reach of children. Cleaning
and maintenance must not be conducted by
children without supervision.
• This apparatus should only be used for its
intended purpose, that is, to motorise a one- or
two-panel gate for vehicle access. Any other use
will be considered dangerous.
• The opening or closing manoeuvre control must
be used with perfect visibility of the gate. Should
the gate be outside the user’s field of vision, the
installation must be protected by a photocell
type safety device, and its operation must be
checked every six months.
• All potential users must be instructed in the use
of the motorised gate by reading this manual. It
must be ensured that no persons who have not
been instructed in the use of the device may set
the gate into motion.
• Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves.
• Avoid any natural obstacles (branch, stone, high
grass, etc.) impeding the gate’s movement.
• Do not manually activate the gate when the
motor drive is not disengaged from the gate.
• Avidsen cannot be held liable for any use that
does not comply with the instructions in this
manual and causes damage.
2 - OPERATING PRECAUTIONS
• Read this entire manual before starting the
installation.
• The electrical installation of the motorised gate
must meet current standards (in particular NF C
15-100) and should be undertaken by a qualified
person.
• The 230 V mains supply must be protected with
a suitable circuit breaker which meets current
standards.
• All electrical connections must be performed
with the power switched off (safety switch in
OFF position) and battery disconnected.
• Ensure that crushing and shearing between
the mobile parts of the motorised gate and
the surrounding fixed parts due to the gate’s
opening/closing movement are avoided or
signalled on the installation.
• The motorised part must be installed on a gate
according to the specifications provided in this
manual.
• The motorised gate must not be installed in
an explosive atmosphere (presence of gas,
flammable smoke, etc.).
• The installer must check that the temperature
range shown on the motor drive is suitable for
the location.
• The wire that acts as an antenna must remain
inside the electronic panel.
• It is strictly forbidden to modify any of the
components provided in this kit, or to use an
additional component not provided for in this
manual.
• During installation, but above all during
adjustment of the motorised gate, you must
ensure that no person, including the installer, is
in the area in which the gate moves at the start
and throughout the duration of adjustment.
• The flashing light is an essential safety
component.
