MOTOR DRIVE FOR 2-PANEL GATES - CONNECT
EN
52
www.mythomson.com
E - OPERATION
1. WARNINGS
A motorised gate is a product that can cause injury
to people and animals and damage to property.
Our motorised gate as well as its installation
and user guides were designed to remove all
hazardous situations.
Avidsen cannot be held liable for any installation
or use that does not comply with the instructions
and causes damage. It is essential to read the
instructions carefully before using your motorised
gate and to keep these instructions for any later
use.
General Safety Obligations
• This device may be used by children 8 years
of age or older and by persons with reduced
physical, sensory or mental abilities or a lack of
experience or knowledge, if they are properly
supervised or if instructions on the safe use
of the device have been provided to them and
the possible hazards have been understood.
Children must not play with the device. Cleaning
and maintenance by the user should not be
performed by unattended children.
• All potential users must be instructed in the use
of the motorised gate by reading this user guide.
• No untrained person (child) must set the gate in
motion using the fixed (key selector) or portable
(remote control) devices.
• Prevent children from playing near or with the
motorised gate.
• Do not deliberately stop the moving gate,
except of course with a control device or for an
emergency stop.
• Prevent any natural obstacles (branches,
stones, high grass, etc.) from hindering the
gate’s movement.
• Do not manually operate the gate when the
motors are not disassembled.
• Before setting the gate into motion, ensure that
there is no person in the area in which the gate
moves (children, vehicles, etc.).
• In the event of a malfunction, disassemble the
motors to allow passage and contact your
installer. Do not attempt to fix the product
yourself.
• Do not alter or add components to the system
without discussing it with the installer.
2. OPENING/CLOSING
The gate can be controlled from a programmed
remote control, a programmed wireless code
keypad or a wired control device.
3. TYPE OF COMMAND
There are two types of command to manoeuvre
the gate:
•
Gate control
•
Pedestrian control
• The gate control controls the opening, stopping
and closing of both panels.
• The pedestrian control is used to control the
opening, stopping and closing of the panel
driven by motor M1.
• The pedestrian control can also be used to stop
the two panels.
• The pedestrian control cannot be used to close
M1 if M2 is not fully closed.
• Automatic closure and photocells are not active
for pedestrian control.
4. OPERATING MODES
The operating mode is set by following the
instructions in the “OPERATING MODE” section.
