41
EN
EN
www.mythomson.com
MOTOR DRIVE FOR 2-PANEL GATES - CONNECT
D - BEGINNING OPERATION
1. SETTINGS INTERFACE
Indicators
•
L0
= Green LED (switched off when the card is
on standby)
•
L1 to L4
= Red LEDs to display information
concerning settings, events (or errors) or
battery status.
Buttons
PROG
= Enter or exit settings menus.
“
-
” / “
+
” = Select a menu item, set a value,
navigate the event log.
OK
= Enter sub-menus, confirm a setting, view
the battery voltage or history of events, enter
manual control mode.
Important notes:
• Buttons can be pressed and released or pressed
and held (for 3 seconds). When the instructions
below indicate “
press the PROG button
,” the
button must be pressed and released. When the
instructions indicate “
press the PROG for 3s
”
or “
PROG 3s
,” the button must be pressed and
held.
• In the instructions below, the operations to be
performed with the buttons will be described
from
MENU 0
. It is the display menu that
appears just after the power has been switched
on for example, just after the gate has moved
(before standby) or even when the card is
on standby (in this case, the green LED L0 is
switched off).
• To make sure you are at
MENU 0
of the display,
press on
PROG
2 or 3 times and only the green
LED should be switched on.
When the user performs no action on a button
for 15 seconds, the system automatically
goes back to MENU 0.
2. BASIC SETTINGS (MENU 1)
2.1. Menu Structure
After it is switched on, all LEDs will be
turned off except the green LED
• If the green LED is off, the card is on standby
mode. Press on
PROG
once (press and
release) to activate the card. If no lights turn
on, check that the power connections are
correct.
• Lit up red LEDs are an error code. Check the
error code table for the meaning. (If the card
has already worked before, the last error code
appears. This does not mean that there is a
problem with the card).
• To clear the display of an error code, press and
release
PROG
once.
Now to enter settings menu 1 (MENU 1),
press PROG for 3 seconds and LED L1 will
turn on.
• Menu item number 1 is selected. Press
+
or
–
to select another menu item and the red LED
for that item will turn on accordingly.
• When a menu item is selected, press OK to
view and change the related setting. See the
chart below. The
+
and
–
buttons must then be
used to change the setting value, and the
OK
button must be pressed to confirm it. If you
do not wish to change a setting, you can exit
by pressing
PROG
repeatedly (until only the
green LED is lit).
