Thermo Scientific thermoscientific Vanquish UHPLC System, Operating Manual

Page: 59 / 148

5 • Installation
UHPLC System
Operating Manual Page 59
Follow these steps 1. Connect one end of the system interlink cable to the System
Interlink port on the system base, and the other end to a System
Interlink port on the pump.
2. Connect one end of the system interlink cable to the free System
Interlink port on the pump, and the other end to a System Interlink
port on the autosampler.
3. Connect one end of the system interlink cable to the free System
Interlink port on the autosampler, and the other end to a System
Interlink port on the detector.
4. Connect one end of the system interlink cable to the free System
Interlink port on the detector, and the other end to a System
Interlink port on the column compartment.
5.4.3 Power Connections
After setting up the Vanquish system as required by the system
configuration, you can connect the modules to the power source. Follow
the steps below. Do not turn on the system or modules yet.
1. Verify that the power switch on each device is set to OFF.
2. Connect the power cord to the power-inlet connector on each
device.
NOTICE
Condensation in a device can damage the electronics.
• Before connecting the devices to the power line, be sure that no
condensation is present in the devices.
• If you suspect that condensation is present, allow the device to
warm up to room temperature slowly. Wait until the condensation is
completely gone before proceeding.
3. Connect the free end of the power cords to an appropriate power
source.
4. Insert the signal and power cables into the cable clips (see Cable
Clips ( } page 60) ).
5. If necessary, move the system to its final position.
6. Lock the system base against moving (see Locking the System Base
( } page 63) ).