Start
Set values
Change act. set val.
Ramp functions
Settings
Internal temp.
External temp
Set value
°
C
°
C
°
C
22.68
21.20
40.00
HAAKE P1 3KW 17:00:00 17:11:
Start
Set values
Change act. set val.
Ramp functions
Settings
HAAKE P1 3KW
!
!
Operating
40
HAAKE Phoenix II P1
Version 3.07
14. Operating
14.1 Switching on
1
Switch on the unit via the mains switch
2
at the tem-
perature control unit Phoenix.
⇒
On the main display two or three temperatures are dis-
played:
On the top right the internal actual temperature
(here: 22.68
°
C)
in the middle the external actual temperature
(here: 21.20
°
C).
Attention: value is only displayed when an external
PT100 sensor is connected.
Below the middle the intended set temperature is dis-
played (here: 40.00
°
C).
Depending on the selected control the corresponding
actual value is displayed in bold numbers.
(e.g. if the external control is activated, the temperature
value of the external PT100 sensor is displayed in bold
numbers.)
This results in the following display if ’AUTOSTART: OFF’
⇒
” start ” appears in the display
2
If need be, change the settings or temperature settings
and „Start“ with the corresponding function key.
The main menu display then shows „Stop“. By pressing
the „Stop“ functional key the control can be stopped at
any time.
If the unit is restarted within about 5 min after stop-
ping via the menu function, the cooling machine is
switched on only with delay for safety reasons.
To increase the life time of the cooling unit we rec-
ommend to wait about 5 min before restarting the
unit after having switched it off via the mains
switch.
This results in the following display if ’AUTOSTART: ON’
The unit begins to work immediately. The pump, heat-
ing, cooling and control functions are active straight
away.
Controlling can be stopped by pressing the „Stop“ key
in the main menu.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
