Thermann TH28ENR6L, Installer Manual

Page: 48 / 52

Thermann Installer's Manual
Gas Continuous Flow Water Heaters
48
3. Connect a Y-shaped terminal of the remote
control cord to a terminal stand of the remote
control in back side.
Push down only section A ( ) of an insulated
cover (clear) to the front, and attach Y-shaped
terminal from an insulated cover (clear) top side.
5. Attach the remote controller to the mounting bracket.
Insert the bottom of the remote controller into the
groove at the bottom of the bracket and push in the
2 hooks on top of the remote controller completely.
* If it is difficult to attach, do not try to force it as it may
result in broken hooks. Check for proper alignment in the
groove or for loose wires obstructing the remote controller.
* Do not install on the
bracket by force, the
hooks may break.
Hooks
Groove
Mounting
bracket
Main remote
controller body
6. Secure the remote using the machine screws.
7. Attach the decorative frame which was
removed in the second step.
Push the 4 corners of the decorative frame until there is a click.
* Incomplete
installation may
result in failures
such as switch
operation failure.
Note: To remove the decorative frame after
installation of the remote controller and
the frame, pull the entire decorative frame
forward while pressing the sections indicated
(where the fingers are) in the figure below.
* If it does not come off,
insert a flat head driver into
the notch at the bottom of
the decorative frame and
slightly twist it to remove
(due caution is required
not to scratch the remote
controller, decorative frame
or the wall in doing so).
Click Click
Click Click
Put fingers into this gap.
Main remote
controller body
Machine screw
(accessory part)
* If the Y-shaped terminal is not covered, the
exposed section may come into contact with
the mounting bracket resulting in improper
operation or failure.
4. Secure the remote controller wires by winding
them around the notches as shown in Fig. 1.
Rear side of the remote controller
Fig. 1
Winding around the notches
Pass the remote
controller wires
through the notch.
Section A
Insulating cover
(Do not remove
the cover.)
Mounting bracket
Remote controller wires
For wiring inside the wall
For exposed wiring
Remote controller cords
(Be careful about the installation
direction of the Y-shaped terminal.)
* Check the terminal is
covered with Section A
( ) of the insulating
cover (clear, see Fig. 1).
THIS SIDE UP
For exposed wiring, use scissors
or shears to carefully cut “the
wires inlet tab” of the decorative
frame to create slot for wires
before attaching to wall mount.
Wires inlet tab
Decorative frame
* Do not remove the insulating cover (clear).
* Be careful about the installation direction of the
Y-shaped terminal.
* Do use an electric driver, the impact screwdriver absolutely.
* The position of a terminal stand changes with
kinds of remote control.