Thermann TH28ENR6L, Installer Manual

Page: 27 / 52

• The appliance is equipped with a 1.5m cable with a three pinned earthed plug to be connected to
230 - 240VAC at 50 Hz.
The power consumption may be up to TH50ECR6 series 288W, TH32ECR6 series 223W,
TH28ENR6 series 193W.
Use an appropriate circuit.
• The appliance requires a 240V in Australia and 230V in New Zealand, 50Hz weatherproof plug installed
in a protected position adjacent to the appliance.
• If the power cord is damaged and requires replacement, use only an original spare part available from
the manufacturer.
• Do not disconnect the power supply when not in use. When the power is off, the freeze prevention in
the water heater will not activate, resulting in possible freezing damage.
• Do not let the power cord contact the gas piping.
Tie the excess power cord outside the water heater. Putting the redundant length of cord inside
the water heater may cause electrical interference and faulty operation.
Electrical Shock Hazard
Do not turn power on until controllers have been connected. Disconnect power before servicing.
Failure to do so may result in death or serious injury from electrical shock.
WARNING
Electrostatic discharge can affect electronic components. Take precautions to prevent electrostatic
discharges from personnel or hand tools during the water heater installation and servicing to protect
product’s electronic control.
CAUTION
Earth
• To prevent electrical shock, always plug power lead into an earthed point.
Electrical Wiring
27