Thermann TH28ENR6L, Installer Manual

Page: 46 / 52

Thermann Installer's Manual
Gas Continuous Flow Water Heaters
46
Confirmation before the setting
(1) (2)
(2)
(2) (2)
(1)
Included Parts List
(The value in ( ) indicates the quantity.)
Remote Controller
Mounting
bracket
Raised countersunk
head wood screw
Wall anchor
Raised countersunk
head screw
(For junction box
installation)
Machine
screw
Post-installation Checks
(1) Check if the remote controller is installed securely.
(2) Verify remote controller operation (see OWNERS GUIDE).
* Press the Power On/Off button approximately 5 seconds after
connecting power to the system.
* Check if the temperature setting on the remote controller is appropriate.
Explanation to the Customer
Explain the “Important Safety
Information”, “Operation Procedures”
and “Follow-up Service” according
to the OWNERS GUIDE supplied
with the water heater.
Introduction
• Make sure that the power is not turned on (the breaker is “OFF” or the power plug of equipment is
disconnected).
• Check the included parts list.
Confirmation before the setting
• Choose a place that is easy to use in consultation with our customers (It is necessary to get the
approval of the visitor).
• Do not be attached to the following place;
1. The place where the temperature becomes higher (near a gas stove)
2. The place where direct rays hit (near a window etc.)
3. The place which requires steam (near a gas stove and a rice cooker etc.)
4. The place which requires a spray (near a hot water tap etc.)
5. The place which requires oil (near a gas stove)
6. The place which uses chemical specialities (Benzine, Oils and fats system detergent etc.)
Confirmation of the remote-control cord
A remote control code has the following length ; 3m, 5m, 8m, 10m, 15m, 20m, 50m, 100m
Please use the thing of required length according to the conditions of the spot.
* Y-shaped terminal is not attached 50m and 100m length code.
For using 50m and 100m length code, please be sure to attach
Y-shaped terminal with a resin sleeve.
Be careful for a mustache not to come out.
When a mustache comes out, please be sure to reattach Y-shaped terminal.
A mustache contacts other parts and causes failure of apparatus.
Y-shaped terminal
with a resin sleeve
mustache