Themis RES-12DCX, Installation Manual

Page: 32 / 144

1-4
Themis Computer
RES-12DCX Installation Manual
The RES-12DCX front panel houses two removable SATA II hard-disk drive bays
(one on the left and one on the right).
Also included on the front panel is a combination CD-RW/DVD-ROM Slimline
drive, a reset switch, and the system power switch and status LEDs (see
Figure 1-5
on page 1-10). The rear panel contains blank I/O faceplates for two PCI cards
(graphics, NIC, etc.), an AC power supply with power-cord socket (DC can also be
ordered), and all I/O connectors (
Figure 1-5 on page 1-10).
Major features of the RES-12DCX are described in Table 1-1 . Major internal com-
ponents can be seen in the open top view (cover removed) of Figure 1-4 on
page 1-6.
Table 1-1. Major Features of the RES-12DCX
Feature Details
Processor (CPU)
z Two dual-core Intel 771-pin Xeon CPUs @ up to 2.33 GHz
z 2-MB or 4-MB L2 cache (per core)
z 667/1066/1333 MHz front-side system bus speed
z On-board Voltage-Regulator Module (per processor)
Chipset
z Intel chipset:
— Memory Controller Hub (MCH)
— 6700 PCI-X Hub (PXH-V)
— Enterprise SouthBridge 6321 I/O Controller Hub (ICH)
Memory
z Eight 240-pin DIMM sockets supporting up to 32 GB of registered ECC DDR2
FBD 667/533 SDRAM
Expansion slots
The following 2 PCI slots are horizontally located on a PCI Riser Card (one
Riser Card per PCI slot) installed in slot 6, slot 7, and one to three PCI-
Express
slots (each slot is PCI Riser-Card dependent):
z Left Slot (Slot 6) : PCI- Express (x8) or PCI-X (64 bit, 133-MHz)
z Right Slot (Slot 7) : PCI- Express (x8) or PCI-X (64 bit, 100-MHz) with ZCR
support
Peripheral Support
z Two removable SATA II hard-disk drives
z One combination CD-RW/DVD-ROM slimline (IDE) drive
External I/O
(through rear I/O Panel)
z 1 PS/2 keyboard port (DIN-6) and 1 PS/2 mouse port (DIN-6)
z 2 USB 2.0 ports—USB 0 and USB 1
z 1 serial port (9-pin)—COM 1
z 2 RJ45 Gigabit Ethernet ports—LAN 1 and LAN 2
z 1 VGA display port
z 4 SAS (Serial-Attached SCSI) ports (single connector)—SAS 4 through SAS 7