Themis RES-12DCX, Installation Manual

Page: 113 / 144

BIOS Setup Utility
BIOS POST Messages
C-37
Themis Computer
Operating system not found
The operating system cannot be located on either drive A: or drive C:. Enter Setup
and see if fixed disk and drive A: are properly identified.
Parity Check 1 nnnn
A parity error was found on the system bus. BIOS attempts to locate the address and
display it on the screen. If it cannot locate the address, it displays
???? . Parity is a
method for checking errors in binary data. A parity error indicates that some data has
been corrupted.
Parity Check 2 nnnn
A parity error was found on the I/O bus. BIOS attempts to locate the address and dis-
play it on the screen. If it cannot locate the address, it displays
???? .
Press <F1> to resume, <F2> to Setup, <F3> for previous
This is displayed after any recoverable error message. Press <F1> to start the boot
process or <F2> to enter Setup and change the settings. Press <F3> to display the
previous screen (usually an initialization error of an
Option ROM ; i.e., an add-on
card). Write down and follow the information shown on the screen.
Press <F2> to enter Setup
An optional message displayed during POST, which can be turned off in Setup.
PS/2 Mouse:
PS/2 mouse identified.
Run the I2O Configuration Utility
One or more unclaimed block storage devices have the Configuration Request bit set
in the LCT. Run an I2O Configuration Utility (e.g., the SAC utility).
System BIOS shadowed
The system BIOS is copied to shadow RAM.
UMB upper limit segment address: nnnn
Display the address nnnn of the upper limit of Upper Memory Blocks , indicating
released segments of the BIOS that can be reclaimed by a virtual memory manager.
Video BIOS shadowed
The video BIOS is successfully copied to shadow RAM.