Themis RES-12DCX, Installation Manual

Page: 52 / 144

2-6
Themis Computer
RES-12DCX Installation Manual
2.1.3 SATA-II Hard-Disk Drive
Perform the following steps to remove and install a SATA-II hard-disk drive.
2.1.3.1 Disk-Drive Removal
To remove a hard-disk drive,
1. Make sure the system is powered off (see “Operation” on page 2-16).
2. Locate the drive to be removed (see A in Figure 2-4 ).
3. Loosen the captive screw of the drive latch handle until it swings away from
the chassis (see
B ).
4. Carefully pull the latch handle (see C ) until the drive has cleared the chassis.
The drive will automatically disconnect from its backplane connector when
pulled forward.
Caution: When pulling the hard-disk drive from the chassis, hold it at the
bottom to prevent it from falling and damaging the drive.
Figure 2-4. RES-12DCX Hard-Disk Drive Removal
Locate the drive to be removed, . . .
A
. . . loosen the drive latch handle, . . .
B
Latch Handle
. . . and pull drive out with the latch handle
C