Terrasat IBUC 3, Operation Manual

Page: 72 / 236

5-2
|
IBUC
3
, IBUC
3 G
Operations Manual: Monitor and Control Features
Engineered to Endure
To initiate an RS232 session,
1. Connect a 19-pin to DB9F cable between the computer and the IBUC.
Figure G.1 on page G-2 contains a drawing for fabricating a cable.
2. Activate a terminal emulation program such as HyperTerminal or PuTTY.
3. Configure Serial RS232 Session with matching baud rate, stop bits, parity, flow
control and stop bit, as given above and connect to the IBUC unit.
4. Once connected press Enter . If the connection process was successful a
IBUC>
prompt should appear.
5. At this prompt type “
CPE=<password>
”. The default password from factory is
1234
. This is the only configurable password in the system and it can be
configured to assume values from
1
to
65535
. Once configured, the user should
use it to perform login to the unit.
At this point, one may enter commands from Appendix F, ASCII Command/Response
Structure .
Note:
The RS232 port is shared with the Hand-held Terminal.
Hand-held Terminal
The Hand-held terminal (HHT) shown in Figure 5.1 is an optional item that can be
used to access the IBUC
3
or IBUC
3 G
via the J2 connector for local monitor and
control. No additional configuration of the IBUC is necessary.
Figure 5.1
Hand-held Terminal
To activate the HHT,
1. Connect the supplied cable to the J2 connector on the IBUC and plug the RJ-11
connector into the HHT.
2. When a flashing cursor is seen in the upper left of the HHT screen, press the
decimal key four times (that is “
. . . .
”).