Tennant M17 Series, Service Information Manual

Page: 23 / 236

2-13
M17 Service Information 90 17358 (0 8 -2016)
GENERAL INFORMATION
OPERATIONAL MATRIx (cont'd)
Output Pin(s) Enable Input Disable Input
Severe environment
pump:
(option)
NOTE: Short and Long
cycle duration times
can be adjusted in
configuration mode.
Scrub mod-
ule:
detergent
pump
J4-1 , CB-6
1-Step on interface
module,
Can-bus
1-Step off interface
module,
Can-bus
Severe environment
Enabled
Scrub mod-
ule, J4-8 Low
or J4-7 Low
Severe environment
Disabled
Scrub mod-
ule, J4-8 Not
Low and J4-7
Not Low
fwd/rev throttle Com-
mand
Curtis pmC,
J1-6 ≈
0.2-5 vDC
neutral - ready State Curtis pmC,
J1-6 ≈ 0 Vdc
Configured for 1%, 2%,
or 3% mix ratio
interface
module,
Can-bus
Configured for 0% mix
ratio
interface
module,
Can-bus
recovery tank full water pu
module, J6-
10 = Ground
Solution tank empty Scrub mod-
ule, J4-1 ≈ <
0.73 Vdc
Low battery Voltage Curtis pmC
module, J1-1
≈ < 32 Vdc
Circuit fault Can-bus to
interface
module
Main Sweep brushes
M ain
Sweep er
module:
Front
J 7-1, J7-2
Rear
J 7-1, J7-3
1-STEP On 1-STEP Off
Sweep er
module:
J 4-4 and
J 4-6 = Not
Grounded
Main Sweep Selected
0.2-5 vDC
Main Sweep Deselected
Curtis pmC,
J1-6 ≈ 0 Vdc
Low battery Voltage Curtis pmC
module, J1-1
≈ < 32 Vdc
Can-bus to
interface
module
M ain Sweep
Actuator
Main Sweep /
Lift module:
actuator
J 4 -1 6 , J 4 -1 7
1-STEP On 1-STEP Off Sweep er
module:
J6-1 = Not
Grounded
interface
module,
Can-bus
interface
Can-bus
module,
Circuit fault
interface
module,
Can-bus
Can-bus to
interface
module
fwd/rev throttle Com-
mand
Curtis pmC,
J1-6 ≈
neutral - ready State
Main Sweep Selected Main Sweep Deselected
interface
Can-bus
module,
Can-bus to
interface
module