Tennant M17 Series, Service Information Manual

Page: 212 / 236

5- 30
SERVICE
M17 Service Information 9017358 (08-2016)
7. Navigate to and select the ‘Set Roll Min’ screen in
Manual Mode
(See page 4-24)
and press the down
pressure button (Standard POD) or ‘checkmark’
button (ProPanel POD) to store the minimum roll
value.
8. Using Manual Mode
(See page 4-24)
controls, extend
the actuator until the hopper stops.
9. Using a Sharpie, mark the rod 0.5 inches from the
end of the cylindrical housing it moves within. This
will be used as a reference point for the next step.
10. Using Manual Mode
(See page 4-24)
controls, retract
the actuator to align the mark in Step 8 with the end
of the cylindrical housing.
11. Navigate to and select the ‘Set Roll Max’ screen in
Manual Mode
(See page 4-24)
and press the down
pressure button (Standard POD) or ‘checkmark’
button (ProPanel POD) to store the maximum roll
value.
12. Key-cycle the machine and lower the hopper to seal
the bumper against the frame using standard
machine controls (This will seal the bumper against
the frame using the normal actuator current limits).
13. Enter Manual Mode
(See page 4-24)
again and
navigate to and again select the ‘Set Roll Home’
screen and press the down pressure button
(Standard POD) or ‘checkmark’ button (ProPanel
POD) to store the hopper home value.
a. The first time this is done is to provide a close
position of the hopper for the machine to use in its
normal mode to seal the bumper against the
frame.
14. Key-cycle the machine to begin using the newly
entered values. Then verify that the hopper lift, roll,
and lower features function properly u sing Manual
Mode controls, extend the actuator .