Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 31 of 54
January 2019
Snappi Seat Standalone User Manual.doc
Central Strap
Weld
Fig. 6
Fig. 5
To fit the sunhood, hold the hood by the two
sunhood tubes and align the push-on clips
(which are on the sunhood tubes) with the
welded support bar on the back of the
Snappi seat (See Fig. 5). Press each push-
on clip (on to the sunhood tube), positioning
them so that the sunhood is at an
appropriate height for the occupant. The
push-on clips can be attached anywhere on
the welded support bars.
The central strap is designed to be an
additional security measure to keep the hood
attached. Once you have clipped the
sunhood onto the welded supported bars,
the straps should be threaded behind the
bars and secured with the attached cam
buckle (See Fig.6). We would recommend
you keep the strap fastened at all times.
Ideally the clips should be located to avoid
the weld on the frame. However, if it is
necessary to position one of the clips on the
weld the strap must be used to secure the
hood.
Welded Support Bar
Push-On Clips
(fitted on
sunhood tube)
