Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 25 of 54
January 2019
Snappi Seat Standalone User Manual.doc
IMPORTANT:
-
In order to ensure
that the harness can
n
ot rise up and cause harm
to the user, every time the harness is in use, you must ensure that all cam
buckles/fixings are properly closed and that the harness is correctly positioned a
minimum of 75mm below the user’s neckline. Failure to comply with this could result
in serious injury.
(On Snappi Seats with 3 side cam buckles)
Thread the bottom straps through the gap at each
side between the back upholstery and hip guides
and down through the cam buckles at the rear of
the side plate. Set at the desired length and
close cam buckle to secure webbing (Fig 5.6.8)
OR
Fig 5.6.8
(On Snappi Seats with 1 side cam buckle) Thread
the bottom straps through the gap at each side
between the back upholstery and hip guides.
Twist the cam catch to one side so you can
access the top of the bolt where you will need to
attach the harness bottom strap (Fig 5.6.9).
Fig 5.6.9
Top of bolt
Twisted cam buckle
