Snappi Seat Standalone User Manual
Document No: 053-07 v5
Page 14 of 54
January 2019
Snappi Seat Standalone User Manual.doc
5.1.2 Footrest Depth and Knee Angle Adjustment
Fig 5.1.2.1
To adjust the foot depth, loosen the 2 securing
bolts (size 1) using the 5mm hexagon key as
shown (see Fig 5.1.2.1). On some size 2
models, wing nuts may be fitted in place of
bolts, and therefore the adjustment can be
made by hand.
Slide the footrest up or down the guide tubes
to the required height as measured in section
5.0
Once set, lock the position by tightening the 2
fixing bolts / wing nuts.
To adjust the knee angle, press in the
angle adjustors on both sides of the
footrest at the same time (see Fig 5.1.2.2),
and lift the footrest guide tubes to the
required angle. To lock, release the
buttons.
Note that the adjustors can only be locked
in 15°
increments.
If the seat is paired with an old style
rearward facing Snappi it may be
necessary to reduce the length of the
footrest stems to avoid the footrest
catching and inadvertently operating the
brake bar. Alternatively the buggy can be
placed in some degree of tilt and space to
avoid this situation.
Fig 5.1.2.2
